9 - ENG
ASSEMBLY INSTRUCTIONS (FIG. 2)
1.
Locate and remove all loose parts from the carton.
2.
Remove the colored quick-connect
or MEG
nozzles
(
if included)
from the
plastic
manual
bag and insert
them into correct grommet on the nozzle
holder
(
if
equipped).
Quick connect n
ozzles are color coded
and will
match
the
nozzle
holder
label.
3.
Connect wand to gun
and t
ighten securely.
4.
Attach high pressure hose to gun
and t
ighten securely.
NOTICE:
The engine is shipped without oil. Before starting engine, add the
provided
oil
. Damage to the engine will occur if the engine is run without oil
.
T
his damage will not be covered under warranty.
NOTICE:
The high-pressure pump was filled with oil at the factory. Always check
oil level before using (refer to
Maintenance
for more information).
OPERATION
PRESSURE WASHER TERMINOLOGY
PSI:
Pounds per Square Inch. The unit of measure for water pressure. Also used
for air pressure, hydraulic pressure, etc.
GPM:
Gallons per Minute. The unit of measure for the flow rate of water.
CU:
Cleaning Units. GPM multiplied by PSI equals CU.
Bypass Mode:
Allows water to re-circulate within the pump when the gun trigger is
not pulled. This feature allows the operator to release the trigger gun and reposition
themselves without having to turn the engine off in between cleaning actions.
1
.
Place the battery into the battery box.
NOTE:
Battery is not supplied, purchase
a 12V garden tractor battery with an ampere rating of at least 18 AH.
2
.
Make sure the battery boots are on the battery cables before connecting to battery.
a.
Connect the positive (red) battery cable to the positive (+) battery terminal.
IMPORTANT:
ALWAYS CONNECT THE POSITIVE (RED) CABLE BEFORE
CONNECTING THE NEGATIVE (BLACK) CABLE. NEVER CONNECT THE
NEGATIVE (BLACK) CABLE FIRST.
b.
Connect the negative (black) battery cable to the negative (-) battery terminal.
c.
Grease the battery terminals and cable ends.
Slide the batter boots over the battery terminals.
IF EQUIPPED WITH ELECTRIC START
