Clock Source
The Scheduler-Timer is synchronized by the 60hz power signal for maximum accuracy. Selecting
N for NO synchronization sets the Scheduler-Timer to operate using the internal clock, which has a
maximum error of + 1.7 seconds per day. For maximum accuracy select Y for YES to synchronize
the Scheduler-Timer to the 60hz power source. Press Up / Down to select Y(es) or N(o).
Press
ENTER
8
button to save.
Use Repeater
The UCS may be used in applications where a sequential, three-phase repeater is installed (e.g.
model UTR). The UCS is not a repeater nor is it capable of repeating a UPB message.
For typical residential operation set: “Use Repeater = N”.
When using with a sequential repeater (i.e. three-phase power) set: “Use Repeater =Y”.
Using the UCS, Controller Scheduler-Timer
The Scheduler-Timer is designed for accuracy and maximum flexibility. Once the UCS is set for time,
date, day of the week, location and Network ID, then all that is needed is setting each event for the
desired ON and OFF time. Upon completion of configuring the Scheduler-Timer, switching from ON
[RUN] to vacation [VAC] or alternate [ALT] vacation mode should be all that is needed for years of
reliable use.
Updating the Controller Scheduler-Timer
From time to time minor firmware updates may be released for the UCS. To check and if necessary
update your UCS to the latest firmware revision, please visit
and follow the instructions. A personal computer with a connection or adapter for a DB9
serial cable is required.
www.Simply-Automated.com/UCS-
UPDATE/
Sync to 60Hz = Y
9)Clock Source
10)Use Repeater
Use Repeater = N
Controller, Scheduler-Timer
Model UCS-01
15
