visit www.simplisafe.com or call 1-888-95-SIMPLI (957-4675) for additional assistance
16
We recommend you test your system regularly and after making any changes.
• In “menu” select “test”
• Follow the instructions on the keypad
• If you subscribe to the SimpliSafe Alarm Monitoring Service, a test signal will
appear in your online account dashboard.
• Press “off” to exit Test Mode. Any errors will be announced by the Base Station.
A. Put your system in Test Mode
Congratulations!
Setup is complete and you can start using your
SimpliSafe system now. Feel free to read on for more information about
your system.
Please remember to test your system regularly.
When in Test Mode, the Base Station will announce each sensor as you test it to
confirm it is working properly:
Motion Sensors:
Press the Test Button on the top of the Motion Sensor. For an
accurate test, leave the room for the sensor you are testing then wait 15 seconds.
Re-enter the room and the Base Station will say “Motion Sensor.”
Glassbreak Sensors:
Press Test Button on the top of the sensor then clap your
hands loudly near your windows. The light on the sensor will turn on for 3 seconds
and you will hear “Glassbreak Sensor” from the Base Station.
Entry Sensors:
Open and close protected doors and windows. The Base Station will
say “Entry Sensor” to confirm that it has received the signal.
Panic Buttons:
Hold the Panic Button down for 2 seconds. The Base Station will say
“Panic Button” when it receives the signal.
Smoke Detectors:
Hold the Test Button on the front of the sensor for 4 seconds. The
sensor will beep 3 times, then the Base Station will say “Smoke Detector.”
CO Detectors:
Hold the Test Button on the front of the sensor for 4 seconds. The
sensor will beep 4 times, then the Base Station will say “Carbon Monoxide Detector.”
Water and Freeze Sensors:
Press the Test Button on the top of each sensor. The
Base Station will announce the sensor type to confirm that it has received the signal.
B. Test your sensors
Step 3.
Test Your System