In this step, you will use the wall carton as a base to unravel the pool wall. Locate the area that you wish to put the skimmer and return so that you
can start to unravel the wall from that point. Unravel the wall a little at a time, inserting into the bottom rails as you go. Do not unravel the entire wall at
once, this makes the installation much more difficult. As you unravel the wall you will need something to hold it up. We recommend placing stakes
around the outside of the pool and clipping the wall to the stakes as you go.
If the side wall seems too long or too short, make the bottom ring larger or smaller by equally sliding the bottom rails in or out of the bottom rail
connectors. If the ground is uneven, the wall may jump out of the bottom rail. Correct this condition by rechecking the ground level.
STEP 4: WALL INSTALLATION
Make sure
skimmer and
skimmer return
holes are
unobstructed
Use stakes to support wall
Wall joint will be
here
STEP 5: WALL JOINT ASSEMBLY
IMPORTANT-
–This operation must be done carefull
y! W
hen joining the sidewall, make sure that the aluminum strips do not touch each
other.
One bar must be inside the pool (the bolts will touch this bar) and one bar must be outside the pool (the nuts will touch this bar). Insert the
bolts with the bolt head to the inside and the nuts to the outside of the pool. Do not tighten until all bolts have been inserted. If your screwdriver slips
and scratches the head of the bolt, file the scratches smooth so that it cannot puncture the liner.
C
over the heads of the bolts, on the inside
of the wall, with three layers of duct tape. If the insertion of the wall in the bottom rail is tight at the point where the wall is joined together, insert a
screwdriver and twist to make enough room, again being sure not to scratch the wall or the bottom rail.
Inside wall bar
Nut goes to
outside of
pool
Outside wall bar
Outside of pool
Inside of pool
S
Ins
ide wall
3/4” Bolts
Pool wall
Wall bar
1/4 Nuts
Inside
of pool
Wall bar
Pool wall
Outside of pool
Top View
