Simplicity 1695821, Operator'S Manual

Page: 13 / 56

7. Use the speed select lever ( E ) to select the forward drive
speed. Set the speed select lever to one of the following posi-
tions as determined by snow conditions:
1-2 Wet, Heavy, Slushy, Extra Deep
3 Moderate
4-5 Very Light
6 Transport
NOTE: When clearing wet, heavy, snow, it is recommended
that the ground speed of the unit be reduced, maintained
full throttle and do not attempt to clear the full width of the
unit.
8. To stop moving forward, release the traction control lever ( D ).
9. To move the snowthrower backwards, move the speed select
lever into either first or second reverse position and engage
the traction control lever.
NOTE: Always release the traction control lever before mov-
ing the speed select lever.
3. Push the deflector control lever ( B ) forward or pull back to
control the angle of the chute deflector. See Discharge
Chute and Deflector in this section.
4. Fully press and hold the auger control lever ( C ) to engage the
auger rotation. Releasing the auger control lever will disen-
gage the auger - unless the Free-Hand™ control is activated.
5. Fully press and hold the traction/Free-Hand™ control lever ( D )
to engage the traction drive and begin moving the snow-
thrower. To disengage the traction drive, completely release
the lever.
6. When BOTH levers are pressed, the Free-Hand™ control is
activated. This allows you to release the auger control lever to
use the other controls. The auger will continue to rotate until
the traction/Free-Hand™ control lever is released.
13
en
OPERATION
STOP THE SNOWTHROWER
1. Release the auger control lever ( C , Figure 4).
2. Release the traction control lever ( D ).
3. Push the ON/OFF switch ( A , Figure 12) to the OFF position
and pull out the safety key ( B ).
WARNING: Read Operator’s Manual before operating
machine. This machine can be dangerous if used
carelessly.
• Never operate the snowthrower without all guards, covers,
and shields in place.
• Never direct discharge towards windows or allow
bystanders near machine while engine is running.
• Stop the engine whenever leaving the operating position.
• Disconnect spark plug before unclogging the impeller
housing or the discharge chute and before making repairs
or adjustments.
• When leaving the machine, remove the safety key. To
reduce the risk of fire, keep the machine clean and free
from spilled gas, oil, and debris.
WARNING: Never run engine indoors or in an
enclosed, poorly ventilated area. Engine exhaust
contains CARBON MONOXIDE, an ODORLESS and
DEADLY GAS.
• Keep hands, feet, hair, and loose clothing away from any
moving parts on engine and snowthrower.
• Temperature of muffler and nearby areas can exceed 150°F
(66°C). Avoid these areas.
• DO NOT allow children or young teenagers to operate or
be near snowthrower while it is operating.
Traction Lock Pin Figure 5
A
TRACTION LOCK PIN
The right traction wheel can be completely released using the
locking pin (
A , Figure 5). This allows the unit to be easily moved
with the engine off.
Not
for
Reproduction