10
TP-400-2561-00-IW-S
Auger Drive and Impeller Group
NOTE: Unless noted otherwise,
use the standard hardware torque
specification chart.
985496
Apply a bead of gasket eliminator
into rear seal groove and flat surface
just past groove (Ref. 15 & 20) on both
halves. Also, apply to bushing bore surface.
Be careful not to over apply as excess will
cause lip seal to not function properly.
Torque to
9 - 11 ft-lbs.
Torque to
30 - 44 ft-lbs.
Torque (Ref. 2) to
17 - 22 ft-lbs.
Hub of pulley
to face auger.
Locate pulley on worm shaft
(Ref. 10) so the belt is 1.94"
from rear of impeller housing.
Apply grease until it appears
at ends of auger assembly.
Auger stamped "L".
Place 1 or 2 washers
per side as required.
Auger stamped "R".
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
2
3
3
17
13
29
28
24
25
23
26
27
The above parts group applies to the following Mfg. Nos.:
1693980
555M, 5HP Manual Start
1693981
555M, 5HP Manual Start (Exp.)
1693982
755M, 7HP Manual Start (Exp.)
1693983
755E, 7HP Electric Start
© Copyright 2001 Simplicity Manufacturing, Inc. All Rights Reserved.
