Surface Mounting Procedure
1. Determine the clock mounting location.
2. Mark two points 10” (25.4 cm) apart, level and centered on the data
cable outlet.
3. Insert two flat-head fasteners suitable for the wall surface at the
marked points and tighten.
4. Withdraw the fasteners until there is a .1/16” (.16cm) gap between the
mounting surface and the back of the fastener head.
5. Insert the data cable into the jack located at the back of the
Simplex
Ethernet Clock
.
6. Position the keyhole slots located on the rear of the clock over the
fastener heads.
Pull the clock slightly downwards until the unit is seated.
©2007 Simplex Time Recorder Co. All rights reserved.
Page 10
