7
Use the following instructions and the figure below to mount the slave DFSM card in an FACP
transponder bay.
1.
Screw two standoffs and washers to the appropriate holes in the back of the cabinet.
These holes must line up with the screw holes in the 4” X 5” card. See Figure 4. The
card can be mounted with the wiring terminals at the top (top PDI row), or with the
terminals at the bottom (bottom PDI row).
2.
Plug the 4” X 5” card into the PDI connector.
3.
Screw two additional standoffs through the holes in the board and into the threaded
inserts in the standoffs installed in Step 1.
4.
Mount the IAM bracket on top of the standoffs. Insert two #6 torx screws and washers
into the standoffs.
Figure 4. Mounting DFSM Slave
Mounting DFSM,
Continued
Slave Card Mounting
Instructions
firealarmresources.com
