TRANSPONDER TERMINAL
MANUAL
4
2.0 WARNING
2.1 SAFETY
−
Specialist knowledge in access control systems, door mechanics, door
approvals and the use of SimonsVoss software is required when installing
a SimonsVoss transponder terminal. This is why only trained specialists
may install this terminal.
−
SimonsVoss Technologies AG accepts no liability for damage caused by incor-
rect installation.
−
Do not allow the Smart Handle to come into contact with oil, paint or acids!
−
Do not try to open the device.
−
Do not drop the device; protect it against impacts and do not shake. If you han-
dle the terminal carelessly, you may damage the electrical circuits and mechani-
cal components inside.
−
When installing the device, ensure no water or damp can get into the housing.
−
Access through a door may be blocked due to defective or incorrectly installed
transponder terminals. SimonsVoss AG is not liable for consequences of incor-
rect installation, such as blocked access to injured persons or those at risk,
physical damage or any other losses.
−
The transponder terminal must be installed in compliance with ESD (electrostatic
discharge) guidelines. You should particularly ensure that you do not touch the
circuit boards and their integrated circuits.
−
Do not pull on the cables.
−
SimonsVoss further develops its products on a continuous basis. SimonsVoss
Technologies AG reserves the right to make changes to any of the explanations
and functions described in this manual without prior notice.
−
This documentation has been compiled in accordance with the best knowledge
available to us. However, errors cannot be ruled out. No liability is accepted in
such cases.
−
Should there be differences in the content of other language versions of this
documentation, the German version applies in cases of doubt.
