9
OWNER’S MANUAL
ASSEMBLING YOUR KIT
ATTACHING THE CYMBAL PADS
1. Insert the two longest cymbal arms into the flat rack
clamps facing behind the rack.
2. Insert the shorter hi-hat arm on the left-side arm’s
cymbal clamp.
3. Remove top wing nut and felt from cymbal arm. Place
cymbal pad on the cymbal arm.
4. Re-attach the felt washer and wing nut. Tighten wing
nut.
NOTE: If you want the cymbal pads closer, you can angle
the bottom section from the clamp and use the “boom” joint
to make the cymbal flat or any angle you want.
ATTACHING THE DRUM MODULE AND DRUMS
1. Loosen wing screws on the snare and tom drum clamps.
2. Place the L-rods into the opening of the drum clamps,
as shown in the image above. The shorter, thicker end of
the L-rod goes into the clamp and the longer, metal end
faces the drummer.
3. Slide the drum pads onto the L-rods. The 10" snare pad
goes on the arm closest to the drummer. The other three
8" tom pads go on the other three clamps.
4. Loosen the module clamp, the one furthest to the
drummer's left. Insert the module into the clamp and
tighten.
BASS DRUM AND HI-HAT PEDAL
1. Place the hi-hat pedal on the floor and to the left, as
illustrated below.
2. Connect the kick drum pedal to the front of the kick
drum pad. The clamp on the back of the kick pedal
attaches to the metal lip on the front of the kick pad.
Replace with your own kick pedal if you want, nearly
any kick pedal should fit the clamp.
3. Place the bass pad and beater pedal on the floor in the
center of the rack as illustrated.
