User manual - METER SWE-73-L
“HdiS”
- type of displayed values:
“
rEAL”
- current value is displayed,
“
HOLd”
- peak (drop) value is displayed,
“H r1”
- relay/LED output R operation mode:
“
rEAL”
- relay/LED operates depend on the current value,
“
HOLd”
- relay/LED operates depend on the peak (drop) value.
7.3.4.
“
Scod” parameter
This parameter defines user password (4-digits number). If this parameter is set at value
“0000”
, user password is turned off.
If the user do not remember his password, the access to the menu is possible
by the “one-use password”. To get this password please contact with
Marketing Division. “Single use password” can be used only one time, after
that it is destroyed. Entering this password causes in clearing of user
password, it means sets the user password to “0000”.
The “one-use password” can be used
ONE TIME ONLY
, it is impossible to use it
again! The “one-use password” can be restored by Service Division only.
7.3.5.
“
dEFS”
parameter
This setting allows to restore the factory settings of the device. To get the access to this
option special password is required: “5465”, next the device displays acknowledge question
“SEt?”
. Press
[ENTER]
to acknowledge the restoring of factory settings or
[ESC]
to cancel.
7.3.6.
“
SErv” menu
This menu contains the parameters for authorized service only. To enter this menu
proper service password must be entered. Improper settings can causes of damage of the
device.
23
i
