Simex STI-94, User Manual

Page: 43 / 52

User manual - RATEMETER STI-94
Register Write Range Register description
58h Yes 0 ÷ 2
“ALArmS” parameter in “rELAy3” menu:
0 - no changes; 1 - on; 2 - off
59h
5Ah
Yes
Yes
0 ÷ 999999 “ SEt P2 ” parameter in “ rELAy3 ” menu, no decimal point included
Parameters or relay R4 operation
60h
61h Yes
Yes
0 ÷ 999999 “ SEt P ” parameter in “ rELAy4 ” menu, no decimal point included
62h
63h Yes
Yes
0 ÷ 99999 “ HySt ” parameter in “ rELAy4 ” menu, no decimal point included
64h Yes 0 ÷ 5
“ modE ” parameter in “ rELAy4 ” menu:
0 - “ noACt ” mode; 1 - “ on ” mode; 2 - “ oFF ” mode; 3 - “ in ” mode;
4 - “ out ” mode; 5 - “ modbuS ” mode
65h Yes 0 ÷ 999
“t on” parameter in “rELAy4” menu, expressed in tenth of seconds
or tenth of minutes depend on “unit” parameter
66h Yes 0 ÷ 999
“t oFF” parameter in “rELAy4” menu, expressed in tenth of
seconds or tenth of minutes depend on “unit” parameter
67h Yes 0 ÷ 1
“unit” parameter in “rELAy4” menu:
0 - seconds; 1 - minutes
68h Yes 0 ÷ 2
“ALArmS”
parameter in
“rELAy4”
menu:
0
- no changes;
1
- on;
2
- off
69h
6Ah
Yes
Yes
0 ÷ 999999 “ SEt P2 ” parameter in “ rELAy4 ” menu, no decimal point included
70h Yes 0 ÷ 1
“ modE ” parameter in “ HOLd ” menu (type of detected changes):
0 - peaks; 1 - drops
71h
72h
Yes 0 ÷ 999999
“
PEA
” parameter in “
HOLd
” menu (minimum detectable change, no
decimal point included)
73h Yes 0 ÷ 199
“ timE ” parameter in “ HOLd ” menu, maximum peaks' (or drops')
display time expressed in seconds
74h Yes 0 ÷ 1
“ HdiS ” parameter in “ HOLd ” menu (the type of values displayed on
the display ):
0 - current measurement value; 1 - peaks (or drops) values
75h Yes 0 ÷ 1
“ H r1 ” parameter in “ HOLd ” menu (the control mode of relay R1 and
LED R1) :
0 - control depends on current measurement values;
1 - control depends on peaks (or drops) values;
76h Yes 0 ÷ 1
“ H r2 ” parameter in “ HOLd ” menu (the control mode of relay R2 and
LED R2) :
0
- control depends on current measurement values;
1 - control depends on peaks (or drops) values;
77h Yes 0 ÷ 1
“ H r3 ” parameter in “ HOLd ” menu (the control mode of relay R3 and
LED R3) :
0 - control depends on current measurement values;
1
- control depends on peaks (or drops) values;
43