Simex SRT-147-XA, User Manual

Page: 35 / 44

User manual - METER SRT-147-XA
Register Write Range Register description
50h Yes 0 ÷ 1
“ modE ” parameter in “ HOLd ” menu (type of detected
changes):
0 - peaks; 1 - drops
51h Yes 0 ÷ 9999
“ PEA ” parameter in “ HOLd ” menu (minimum detectable
change, no decimal point included)
52h Yes 0 ÷ 199
“ timE ” parameter in “ HOLd ” menu, maximum peaks' (or
drops') display time expressed in seconds
53h Yes 0 ÷ 1
“ HdiS ” parameter in “ HOLd ” menu:
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
54h Yes 0 ÷ 1
“ H r1 ” parameter in “ HOLd ” menu :
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
55h Yes 0 ÷ 1
“ H r2 ” parameter in “ HOLd ” menu:
0
- “
rEAL
” mode ;
1
- “
HOLd
” mode
56h Yes 0 ÷ 1
“ H r3 ” parameter in “ HOLd ” menu:
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
57h Yes 0 ÷ 1
“ H r4 ” parameter in “ HOLd ” menu:
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
58h Yes 0 ÷ 1
“ HOUt ” parameter in “ HOLd ” menu:
0 - “ rEAL ” mode ; 1 - “ HOLd ” mode
A0h 1 Yes 0 ÷ 2
“ Omod ” parameter in “ OUtP ” menu (current output mode)
0 - current output disabled ; 1 - current output enabled with
4 ÷ 20mA mode; 2 - current output enabled with 0÷20mA
mode ;
3 - current output controlled via RS-485 interface
A1h 1 Yes -999 ÷ 9999 “ OUtL ” parameter in “ OUtP ” menu, no decimal point included
A2h 1 Yes -999 ÷ 9999 “ OUtH ” parameter in “ OUtP ” menu, no decimal point included
A3h
1
Yes 0 ÷ 999
“ Lo r ” parameter in “ OUtP ” menu, expressed in 0.1%
A4h 1 Yes 0 ÷ 199 “ Hi r ” parameter in “ OUtP ” menu, expressed in 0.1%
A5h 1 Yes 0 ÷ 3
“ AL ” parameter in “ OUtP ” menu (current output value on
critical exception):
0
- no change;
1
- 22.1 mA;
2
- 3.4 mA;
3
-
0 mA
1 - these registers are active only if device is equipped with active current output
2 - after writing to register no 20h the device responds with an “old” address in the message.
3 - after writing to register no 22h the device responds with the new baud rate.
4 - the value of the “ mbAc ” parameter is also connected to write to this register, so it is possible to block a writes, but
impossible to unblock writes via RS-485 interface, The unblocking of the writes is possible from menu level only.
35