5
4
17
18
19
21
20
17. Speaker Panel
18. Exciters (Piezoelectric
Drive Elements)
19. Receiver Input
20. Fastening Knob
21. Mount
Simeon Omnipanel 900 Flat Panel Loudspeaker
Figures 3 & 4
Simeon 5T and 6T Pendant Transmitter
The 5T Transmitter has 96 channels available over an UHF frequency band
to allow for the best possible sound quality and performance. The Simeon
6T Transmitter offers 16 high definition digital audio channels, each with two
positions (A & B) that allow for easy setup of two transmitters side by side, and
can be used in any country. Your transmitter can be interfaced with a boom
(headset) mic, as well as other audio inputs. It can either be used as a hand-held,
or worn around the neck or at the waist in conjunction with a boom (headset)
mic. It is recommended that you charge the transmitter fully before its initial use.
It is possible to adjust your transmitter microphone sensitivity to accommodate
non-standard microphones and other special requirements. If you need to
change the microphone sensitivity please contact your point of sale for advice.
Transmitters 5T and 6T come with a high capacity rechargeable lithium battery
preinstalled. They should be charged only with the recommended Simeon
charger.
Simeon 5M and 6M Hand-held Transmitter/Microphone
5M and 6M are hand held pass-around microphones.
Open the transmitter battery compartment [42] and insert two NiMH
batteries (supplied), taking care to observe the correct battery polarity.
Never
use disposable (alkaline) batteries in combination with the charging system.
It
is recommended that you charge the transmitter fully before its initial use. The
5M and 6M should be charged only with Charger 602.
Inside the 6M battery compartment there is a Main (M) and Secondary (S)
mode switch. To maintain remote control over the hand-held microphone from
the pendant transmitter, the switch should be kept in the S position. If you wish
to use microphone 6M independently from the pendant transmitter, this switch
must be in the M position.
Simeon Charger 602 Transmitter Charging Cradle
Charger 602 allows for the easy simultaneous charging of any two Simeon 5T,
6T, 5M, or 6M Transmitters, in any combination.
Identify the correct power cable for the charging cradle. Plug in the cradle
[29]. Place the transmitters into the Charging Pockets [30]. When inserting the
5T and 6T transmitters, make sure the front of the receiver is facing towards the
centre of the charging cradle. The transmitters will turn off automatically when
they are placed in the charging cradle. A steady red ‘ON’ charging indicator will
light during charging; a steady green indicator will light once charging is complete
[31]. Internal charging circuitry will sense when charging is complete and will
terminate charging automatically. Flashing red indicates a failure to charge.
Check and replace batteries as necessary.
