1.1
INTRODUCTION
The Sime
“SUPER”
family is a fully automatic, wall moun-
ted, room sealed, fan assisted range of combination boilers.
The above appliances can be fuelled with natural gas and
provide central heating and instantaneous production of
D.H.W. The heat output varied according to the demand on
both D.H.W. and C.H modes.
The appliance is supplied with a concentric air and flue duct
suitable for flue lengths of up to 0.83 m (32
1
⁄
2
in) although
extension duct kits are available and may be used up to a
flue length of 2.4 m (94
1
⁄
2
in). The combined flue and air
duct can exit the boiler from either side or from the rear of
the appliance. A vertical extension and additional flue elbow
may be fitted.
The boiler is designed for use with sealed primary water
systems and is supplied fully assembled and equipped with
complete valve packs; a D.H.W. expansion vessel is available
upon request on
“90”
model.
If the wall thickness is less than 0.5 m (19 in) the appliance
can be installed from inside the room without access to the
external wall although a wall liner is required. This is available
as an optional extra, and full details are given in section 3.
All boilers may be used with a 24 V room thermostat. A 240
V room thermostat may be fitted if a 24 V model is not avai-
lable, but its sensitivity will be reduced (refer to section 2.7
for details).
The Sime
“SUPER”
features an attractive white enamelled
casing with a moulded white plastic control box and facia
panel.
1
1
TECHNICAL FEATURES AND DIMENSIONS
TABLE 2 - Minimum clearances
mm
in
ABOVE THE APPLIANCE CASING
200
8
AT THE R.H.S.
90
3
1
⁄
2
AT THE L.H.S.
30
1
1
⁄
4
BELOW THE APPLIANCE CASING
200
8
IN FRONT OF THE APPLIANCE
450
18
TABLE 1 - Connections
R
C.H. return
22 mm
Compression
M
C.H. flow
22 mm
Compression
G
Gas connection
1
⁄
2
in
Bsp
E
Cold water
15 mm
Compression
U
Hot water
15 mm
Compression
S
Safety valve
15 mm
Copper
1.2
DIMENSIONAL DETAILS
Fig. 1
L
= 450 mm (
“SUPER 90”
)
500 mm (
“SUPER 102”
)
P
= 225 mm (
“SUPER 90”
)
295 mm (
“SUPER 102”
)