23
EN
Centre the water storage tank’s position on the collector/s. Rotate the water storage tank (if necessary) in order for the cold and hot
domestic water sockets to remain vertical to the horizontal surface. Screw the water storage tank onto the base using the screws pro-
vided in the packaging. Ensure the appliance is not tilted and is properly levelled. It is necessary to use a level.
Place the small flexible tube on the special connection ¾”xDN16 INOX* at the water storage tank’s side where the heating element is
located and to the socket marked “collector intake”.
STEP 17
STEP 16
STEP 19
STEP 14
STEP12
*
Join the other end to the top left socket of the collector using the Ø22xDN16 INOX corner fitting*, having firstly passed the tube through
the insulation pipe.
Place the Τ-piece with the filling valve to the socket on the right side of the water storage tank marked “collector return”. Place the big
flexible tube with the special connection to the T-piece on the right side of the water storage tank.
Place the other end at the bottom right socket of the collector using the Ø22xDN16 INOX corner fitting*, having firstly passed the tube
through the insulation tube. Tighten all unions in the system as well as all the screws on the base. Do the hydraulic connection, fill the
closed loop and do the electrical connection as described in the relevant sections. Check for leaks.
After having placed the collectors at a parallel to each other position, fasten them to the support base tightening the fixing washers 8.
Fit the water storage tank supporting base covers 9.
* Use two wrench keys in order to avoid the copper tube mechanical strain.
