4
IQ Power Wireless Link
5201319 Rev B
4. INSTALLATION
NOTE
– DO NOT USE standard Ethernet cables with IQ Power systems.
Avoid permanent equipment damage by using only Simco-Ion modular
cables. (Refer to Section 8, Parts and Accessories).
Figure 1. IQ Power Crossover Modular Cable (black) Wire Diagram
System Setup
NOTE
– ADDRESS ALL IQ POWER AND IQ EASY DEVICES FIRST.
All devices must be individually addressed before connecting to the IQ
Power Hub.
The following steps must be taken in this order to properly install the Bluetooth
Adapters and Hubs:
• Address all IQ Power/IQ Easy devices individually before connecting to the
IQ Power Hub
• Configure the Control Station for wireless communications by setting to
Wireless or Legacy Mode if necessary
• Connect the Bluetooth Adapter labeled “for Control Station” to the Control
Station, connect the Bluetooth Adapter labeled “connect to Hub” to each IQ
Power Hub being used. Power up the devices and verify communications
• Mount all hardware
• Connect the IQ Power/IQ Easy devices to the IQ Power Hub
• Make all necessary electrical connections
• Confirm the devices are communicating on the Control Station home screen.
Device Addressing
NOTE
– Devices must be addressed individually BEFORE connecting to
the IQ Power Hub
