9
IQ Power Wireless Link
5201319 Rev B
Electrical Connections
Connect Ground
: Ground IQ Power Hub by connecting ground lead between
ground terminal on flange of the hub and a good electrical machine ground.
Connect AC Adapter
: Connect AC Adapter (if used, AC adapter is not required
if the Hub is connected to user 24 VDC power). Route low voltage wire clear of
moving machine parts and protect it from abrasion. Secure using nylon wire ties
(not supplied). Do not over tighten. Insert barrel connector into power connector
on Hub. Hand tighten barrel connector nut to secure.
Connect line voltage to input side of AC adapter. The AC adapter is a universal
input type that accepts line voltage from 100 to 240 VAC 50/60 Hz. The AC
adapter line voltage connector accepts a line cord with an IEC 320 connector
(supplied). The line cord also provides electrical ground to the AC adapter. Check
electrical ground integrity in the line voltage receptacle used for the AC adapter.
This ground must not be defeated.
Connect User Supplied Power
: Connect user supplied power (if used). In cases
where the user does not want to use the AC adapter but wants to supply 24 VDC
power to the IQ Power Hub, user supplied 24 VDC power may be applied via a
removable 2-position pluggable header (3.81 mm / .150” centers). The connector
accepts up to 16 AWG wire with a strip length of 7 mm [1/4”]. To install wires into
the connector, push the stripped wire fully into the square hole on the connector and
tighten securely with a small flat-blade screwdriver. Connection should be made as
shown below:
The user power connector is adjacent the connector for the AC adapter.
1
2
_
+
Figure 4. IQ Power Hub User Power Connection
Power supplied must be 24 VDC with a grounded negative polarity. Power supplied
must have adequate current available to power all components on the system
(maximum 4A). Input power should be appropriately fused for safety purposes.
Connect the Bluetooth Adapter
: Cables used to connect the Bluetooth Adapter
are standard IQ Power modular cables (ref. Fig. 1). Where the Bluetooth Adapter
is connected to the IQ Power Hub, connect the cable to any available RJ-45 socket,
1 through 4. Where the Bluetooth Adapter is connected to the IQ Power Control
Station, connect the cable to any available Power & Comm RJ-45 socket, 1 through
10.
