Sima EUROTRON PLUS, Original User Manual, Page: 21 / 50

4
ENGLISH
3. TRANSPORT
The machine is packed in the factory on a pallet, easy to lift with forklifts or hand pallet trucks. Due
to its dimensions and weight (See the technical features table in this manual), it is possible to transport it in light
vehicles.
When it is needed to transport the machine for too long distances by vehicles, cranes or other means of
elevation, the latter should be safe.
By lifting the machine with cranes or hoists, normalised slings must be used. These are chosen en function of
the required work load limit, the way of use and the nature of the load. The choice is correct if special norms of use
are respected.
ATTENTION: To avoid any possible danger, stay away from elevated loads and be careful with their possible
displacement during transport, whether during lifting or mooring. Therefore, it is essential to choose the
correct slings and remain particularly vigilant in sensitive operations (elevation, coupling, mooring or
discharging).
4. SUPPLY CONDITIONS.
Circular saws SIMA EUROTRON PLUS model is supplied in sealed packaging and reinforced wooden pallet with
the size just to fit the pallet. The machines are introduced on the package so that it can withstand storage at various
heights if necessary.
When you open the package the user will find the following elements:
• Table is ready.
• Hard steel with carbide teeth disc ø 315 mm.
• Axle and wheels are ready.
• Instruction manual and its warranty.
A box with the following accessories:
1. Protection blade
2. Aluminium Rule
3. Rule support with its elements.
4. Pusher
5. Driving device
6. Splitter knife
7. Key kit
8. Screws to set the splitter knife
5. ELECTRIC CONNECTION AND ADEQUACY OF DIRECTION OF ROTATION
When you receive the machine and before connecting to the electric supply. We will make sure the mains voltage is
correct to connect the machine; the operating voltage of the machine is visible through the indication of voltage switch
next to it.
WARNING: Do not connect the machine to the electric supply. If you are not sure of the supply voltage
available, otherwise if the tension was not the right engine would be irreparably damaged and unusable and
unserviceable.
Once you have completed the previous step before inserting the disc and to handle the engine, it is necessary to check
and adjust the rotation of the motor shaft to the proper rotation direction, connect the machine to the electric supply.
and implement it, noting the direction rotation to be clockwise if necessary and with three phase motors can change
the direction of rotation if the exchange between two drivers in phase at the air base or the extension cord plug that
will feed the machine.
If necessary the exchange of electrical wires to change the direction of rotation of the engine, always do it with the
machine disconnected from the electric supply...
WARNING: NOT touch the power cables or electrical lead wires of the machine, if not totally disconnected
from the electric supply.
Once you've got to adjust the direction of rotation of the engine, the machine will be available to
assembling the blade.