ENG
66
5. TRANSPORTATION AND STORAGE
The machine has two handles (A) and wheels (B) to be trans
-
ported by one or more operators. Whenever you need to
move the machine, block the cutting unit using the knob (C)
to avoid unexpected movements that could cause damage.
•Remember to always store the machine horizontally and
well supported.
•Do not rest other loads on the machine to avoid damage.
•Do not store the machine sideways
6. ELECTRIC CONNECTION
When you receive the machine and before connecting it to
the network, make sure that the mains voltage is correct to
connect the machine. The operating voltage of the machine
is visible on the angle grinder.
WARNING: Do not plug the machine in the mains if you are
not sure of the available supply voltage: if the voltage is not
correct, the motor will suffer irreparable damage, or it will be
unusable and out of service.
Once the previous step has been carried out, it is necessary
to check the direction of rotation of the motor as indicated by
the arrow on the disk guard. Check the direction of rotation
on starting.
WARNING: Never handle the power cables of the wires or
electrical equipment of the machine unless you have com-
pletely disconnected the electrical power from the network.
The electric equipment of the cutters has a IP54 degree of
protection.
NEVER WORK WITH WATER TO REFRIGERATE THE
DISC IF YOU DO NOT HAVE THE PRCD WIRE.
Optional accessory available upon order request.
19
22
20
21
on
on
