- 10 -
ENGLISH
8.5
SEGMENTS LOSS
If during the drill you notice you are losing segments or metallic parts of the crown, leave this hole and make
another drill in the same axis with a bigger diameter in 15 and 20mm.
8.6
SUDDEN DETENTION OF THE CROWN
Be cautious when you are drilling, the machine can suddenly stop. The machine has been equipped with a
mechanical clutch, but a quick action to disconnect the crown is also needed. When the crown is blocked, all parts of
the machine can suffer an overload.
Be careful and always prepared to remove the crown if it gets stuck.
To extract the crown, proceed as follows:
1.
Unplug the machine.
2.
Turn the crown with a monkey spanner by means of the hexagonal nut that worms in the axis supporting
the crown.
3.
If you do not manage with a monkey spanner, try it gently with a chain spanner around the frame.
WARNING: Do not turn the machine using the “ON” and “OFF” buttons as this can get the crown
stuck and damage the motor.
9.
SAFETY RECOMMENDATIONS
The drills should be used by trained people or people familiarized with their operation.
•
Before starting up the machine please read the instructions and make sure safety norms are respected.
Learn how to stop the machine in a fast and safe way.
•
Do not use the machine around inflammable liquids gaseous atmosphere.
•
Place the machine on a plane surface. Connect the machine to the electricity only when you are sure of its
stability.
•
Make sure the machine is in a perfect technical state and totally operational before using it.
•
Start the machine only when you have mounted the safety guards that come with the machine.
•
It is recommended to use safety glasses, safety boots, gloves etc. Please always use approved materials.
•
Always use Individual Protection Equipment (IPE) in accordance with the type of work you are effectuating.
•
Prohibit strangers to access the place of work of the machine.
•
Work clothes are not supposed to have loose articles that can cling into movable parts of the machine.
•
When you have to move the machine, unplug the electricity cables and block the moving parts of the
machine.
•
Never use the machine for purposes other than those it has been designed for.
•
Machines with an electrical motor should always be connected to a normalised switch board that
has a magneto-thermal and a differential in accordance with the motor characteristics:
•
VERY IMPORTANT:
Always use earth plug before starting-up the machine.
•
Use normalised extension cables.
•
Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the machine.
•
Make sure the feeding extension cable is not in contact with high temperature points, oil, water, sharp edges.
Avoid also trampling or crushing the cables by passing people or vehicles and do not put any objects on the
machine.
•
Do not use high pressure water to clean circuits or electrical elements.
•
The damaged electrical cables should be urgently replaced.
•
Always keep protection elements in their due positions.
•
Unplug the machine from the electricity and never manipulate nor operate on the mechanical nor electrical
elements of the machine while the engine is on.
