simasa.com
· 39
ENGLISH
7.1. Correct use
7.1.1. Place the arm A unit in a 45° angle
over the rebar cross surface and push
the mouth towards the rebar.
7.1.2. Place Arm A vertically on top of
the rebar cross surface and push the
mouth towards the rebar.
During use
Do not move the RE-BAR tier
while it is tying.
7.1.3. The ties should be made in
alternating directions.
7.2. Cross-tying.
Bend down the knot of the first tie, before
you make the second tie.
8. Maintenance
8.1. Clean and check the RE-BAR tier on
a regular basis.
8.2. The RE-BAR tier requires no lubri-
cation.
Do not use any kind of lubrication on the
RE-BAR tier. This may damage the RE-
BAR tier.
8.3. Clean the feeding gear and sur-
rounding areas on a regular basis, to
avoid dust and metal residue getting
into the machine and causing problems.
This can be done with an air blow gun.
9. Storage
The RE-BAR tier must not be stored in cold
conditions. It should be kept at approx.
20°C. When the machine is not in use,
it should be stored under warm and dry
conditions. Keep the machine out of the
reach of children.
10. Troubleshooting / repairs
The RE-BAR tier will eventually need main-
tenance service and replacement of worn
parts due to normal wear and tear.
Troubleshooting and/or repairs are only
to be carried out by authorised dealers or
specialists.
The RE-BAR tier warns about malfunctions
using beep sounds. Follow the matrix on
page 40 to find out what is wrong.
WARNING
If one of the problems listed on
page 40 occurs, set the main
switch to 0 position, before trying to solve
the issue.
When the main switch is set to 1 - do not
place your fingers near the curl guide or
other moving parts of the machine. If the
problem still occurs, contact your dealer.
Arm A Unit
45°
!
!
Summary of Contents for ATA 400 RE-BAR 25
Page 1: ......
