10
SWITCHING OFF AND RETURNING TO STAND-BY
By remote control: press
By keyboard: press key
When switching off, the projector goes in to stand-by
memorising the input selection at the time of switch-off.
The fans will continue to work until the lamp has cooled down
(red and green LEDs flashing) and will stop automatically after
this period.
LED INDICATORS
The LED indicators, located in the top-rear of the projector,
provide information about the state of the projector (see table
below).
6 CONNECTIONS
To obtain the best performance from your projector, we
recommend the use of good quality “video cables” to the various
signal sources (75 ohm Impedance).
Poor quality cables will cause inferior picture performance.
For optimum connectivity we recommend you follow these
simple steps:
-
With exception of coaxial RCA/Phono type connectors,
always double-check that the plug is inserted the correct
way round to avoid damaging the plugs or the sockets on
the projector
(Fig. 16)
.
HDMI
AUDIO
OUT
ZOOM
CONTROL (RS 232)
GRAPHICS RGB
R/Cr
G/Y
B/Cb
HV
1
2
4
3
5
la protec
remplacer pa
r un
u
et de mems car
acter
istique
CAUTION:
for contin
ued protection ag
ainst
risk of fire
, replace
only with same type
and r
ating fuse
.
75
Fig. 16
-
Remove cables by the plug and do not pull on the cable
itself.
-
Avoid tangled cables.
-
Position the cables carefully to avoid a trip hazard - especially
in low light areas.
POWER OFF
INITIALIZATION
STATE
NOTES
INDICATORS
GREEN
RED
STANDBY
OPERATING
COOLING LAMP
WARNING
ERROR
The Power is turned off
Power button has been pressed and the software is initialized (15 s)
Projector is in standby mode
Projector is on
Projector is powering down; the fans are running to cool the lamp (1 min)
Problems to display one or more source
Internal circuit failure
OFF
ON
OFF
ON
OFF
OFF
ON
ON
OFF
FLASHING
FLASHING
FLASHING
OFF
FLASHING
Downloaded From projector-manual.com Sim2 Manuals
