Silverline ISC 19001, User Manual

Page: 28 / 41

7
The supply voltage corresponds to the specifications on the data plate on the front
of the oven.
The mains supply has an efficient earth (ground) connection complying with all
applicable laws and regulations. Correct earthing (grounding) is a legal requirement.
The power cable should never reach a temperature 50° C above ambient temperature
at any point along its length. If a fixed appliance is not provided with a power cable
and plug, or some other device permitting it to be disconnected from the mains
electricity supply, with a gap between the contacts big enough to guarantee class III
overvoltage protection,
then such a device must be fitted to the power supply in compliance with the
regulations governing electrical installations. The socket or switch must be easily
reachable with the oven fully installed.
WARNING: Before connecting the warming drawer to the electrical circuit, verify
that the voltage and the frequency correspond to those indicated on the label located
inside the heating block, which should be kept along with this manual.
The electrical attachment must be made using bipolar switch capable of powering the
appliance and that has a gap of 3 mm (minimum) to guarantee disconnection in case of
emergency or when cleaning the warming drawer.
Connect the appliance to the ground circuit to conform to safety regulations regarding
electrical systems.
ATTENTION: THE WARMING DRAWER MUST BE CONNECTED TO THE GROUND
CIRCUIT.
In the event of the failure of the cable supplied with the warming drawer, replace it
with an original replacement part provided by the Service Department.
CABLE TYPES AND MINIMAL DIAMETERS
SASO
H05RRF-3x1,5 mm² H05RRF-3x2,5 mm²
H05VVF-3x1,5 mm² H05VVF-3x2,5 mm²
H05RNF-3x1,5 mm² H05RNF-3x2,5 mm²
H05V2VF-3x1,5 mm² H05V2VF-3x2,5 mm²