8
•Should some sugar fall nonetheless
into the bottom section
9
, proceed as
described in “8. Faults and remedies”
on page 11.
5. Unpacking and setting up
Note:
As the appliance and heating
elements
5
are supplied with a thin film of
grease, there might be a
small
amount of
smoke and odour the first time the appliance
is used. This is not harmful and will stop after
a short while. Please ensure meanwhile that
there is sufficient ventilation.
1. Remove the individual parts from the
packaging.
2. Check that all the individual parts are
complete (see “1.2 Scope of supply” on
page 3) and there are no signs of
damage.
3. Clean the appliance thoroughly before
using it for the first time (see
“7. Cleaning” on page 10).
4. Place the candyfloss bowl
6
on the
bottom section
9
.
5. Turn the candyfloss bowl
6
anticlockwise so that the candyfloss
bowl engages in the locks
7
.
6. Position the carameliser
2
on the drive
shaft
4
.
Note:
There is a cross pin located in
the drive shaft
4
. This cross pin must grip
into the lower indentation on the
carameliser
2
.
7. Position the splash guard
1
onto the
candyfloss bowl
6
.
8. Place the appliance on a level, dry, non-
slip surface, so that the appliance can
neither topple over nor slide down.
7
4
RP75819 ZuckerWG LB4 Seite 8 Dienstag, 24. Juli 2012 9:44 09
