Silvercrest SSP 2600 A1, Operating Instructions Manual

Page: 13 / 112

SSP 2600 A1
■ 10
│
GB
♦ If you want to stop the
Bluetooth
®
connection
with your selfie stick, for instance, to separate the
devices, press the On/Off button
for 2 seconds.
The
Bluetooth ®
LED flashes 3 times. The
charging status LEDs light up and then go off
after about 30 seconds. The
Bluetooth
®
function
is now turned off.
NOTE
► Press and hold the On/Off button of the selfie
stick for 2 seconds to turn on the
Bluetooth
®
function. The
Bluetooth
®
LED lights up for
approx. 7 seconds.
The charging status LEDs
light up and then
go off after about 30 seconds. The devices are
now connected via
Bluetooth
®
. You may have
to confirm the
Bluetooth ®
connection on your
smartphone.
Assembling the selfie stick
♦ Screw one of the threads on the mount onto the
thread of the tripod head . You can assemble the
mount vertically or horizontally. Fix the required
position using the fastening screw .
♦ Push the telescopic shaft into the holes on the
selfie stick handle. Turn the telescopic shaft clock-
wise a little until the telescopic shaft clicks into
the selfie stick. The telescopic shaft and the
selfie stick are now connected to each other.
Attaching a smartphone to the selfie stick
♦ Open the mount by pulling the spring clip open.
♦ Place your smartphone into the mount .
♦ Release the clip so that the clip snaps onto your
smartphone. Ensure that your smartphone is firmly
in place in the mount
.
♦ Set the vertical tilt angle of the smartphone. Loosen
the fastening screw hinge joint
3 on the mount by
turning it anticlockwise. Lock the smartphone into
this position by turning the fastening screw hinge
joint
3
clockwise.
♦ Set the horizontal alignment of the smartphone.
Undo the fastening screw
on the mount by turn-
ing it to the right. Turn the fastening screw to the
left to lock the smartphone into this position.