Silvercrest SPDP 18 A1, Manual

Page: 38 / 165

■ 28
│
GB│IE
SPDP 18 A1
Setting up
Check package contents
(See fold-out page for illustrations)
DANGER
► Do not allow children to play with packaging materials .
There is a risk of suffocation!
♦ Remove all parts of the device and the operating instructions from
the box .
♦ Remove all packing materials and the protective films from the
screens .
♦ Remove the transport lock from the DVD drive .
The following components are included in the delivery:
▯ DVD player
▯ Second monitor
▯ Remote control
▯ 2 headrest brackets
▯ 2 securing straps
▯ 8 spare screws
▯ Mains adapter
▯ Car adapter
▯ AV/DC cable
▯ AV cable (3 .5 mm jack plug to cinch)
▯ 2 x AAA/Micro batteries
▯ 2 earphones
▯ Transport bag
▯ Quick start guide
▯ These operating instructions
NOTE
► Check the package for completeness and signs of visible
damage .
► If the delivery is incomplete or damage has occurred as a result
of defective packaging or during transport, contact the customer
service hotline (see
Service chapter) .
Inserting/changing the remote control batteries
♦ Open the battery compartment
5$
on the rear of the remote
control .
♦ Insert two AAA/Micro batteries into the remote control, as shown
in the battery compartment
5$
.
♦ Close the battery compartment
5$
again .
Connecting the power supply
In order to use the device, you must connect the power supply .
You can connect it to a mains socket or operate it using the integrated
rechargeable battery or the car adapter .
CAUTION
► Make sure that all devices are switched off before connecting
them . Do not switch on the devices until all connections have
been established .
Mains power operation:
♦ Insert the plug of the supplied mains adapter
6(
into the DC IN
socket
e
on the side of the DVD player A .
♦ Plug the mains adapter
6(
into a mains socket that is always within
easy reach .
Operation using the car adapter:
CAUTION
► The car adapter
7)
is not suitable for use with a 24 V on-board
power socket .
♦ Insert the plug of the supplied car adapter
7)
into the
DC IN
socket
e
on the side of the DVD player A .
♦ Connect the car adapter
7)
to a suitable 12 V on-board socket,
e .g . the car's cigarette lighter .
Charging the DVD player battery
Once you have connected the power supply, the integrated recharge-
able battery in the DVD player
A will charge automatically . During
charging, the charging LED
d
lights up red . As soon as the battery is
fully charged, the charging LED
d
turns off .
NOTE
► If the DVD player A is not going to be used for some time, the
battery should be recharged at regular intervals to maintain
battery performance .