Silvercrest SKD 2300 D4, Operating Instructions Manual

Page: 14 / 44

GB │ IE │ NI │ 11 ■ SKD 2300 D4
Handling and operation
NOTE
► All functions can be used with the buttons on the device as well as with the
remote control
25
.
This section provides you with important information on handling and using the appli-
ance.
Switching the appliance on and off
The main switch
8
disconnects the appliance fully from the mains power supply.
♦ Insert the power plug into a mains wall socket.
♦ Switch on the appliance using the main switch
8
first; or switch off at the main
switch last if you are no longer using the appliance.
♦ When switched on, the integrated control lamp in the main switch
8
lights up.
There will be a beep and the display
2
lights up.
♦ Now press the on/off button
21
or
33
. The appliance is now ready for use.
Selecting the temperature
NOTE
► The display
2
shows the set target temperature
19
and measured actual
temperature
20
.
► The temperature measurement is made by the temperature sensor
7
. It may
take some time until the whole room has reached this temperature.
♦ Press the button (°F / °C)
23
or
28
to select the unit of measure, to select
whether the temperature display uses °C or °F.
The selected unit of measurement
13
is shown on the display
2
.
♦ Press the „Increase temperature“ button,
15
or
32
, to increase the target
temperature
19
up to a maximum of 37°C (99°F).
The selected target temperature
19
is shown on the display
2
.
♦ Press the „Decrease temperature“ button,
16
or
29
, to decrease the target
temperature
19
down to a minimum of 5°C (41°F).
The selected target temperature
19
is shown on the display
2
.
Select heat setting
The heat setting determines how quickly the appliance warms up.
The appliance has three heat settings:
■ Level 1: 1000 watts
■ Level 2: 1300 watts
■ Level 3: 2300 watts
♦ Press the button to select the heat setting
24
or
26
repeatedly until the
desired heat setting has been set.
The selected heat setting
10
is shown on the display
2
.