Silvercrest SKD 2300 D4, Operating Instructions Manual

Page: 12 / 44

GB │ IE │ NI │ 9 ■ SKD 2300 D4
Before initial use
■ Remove all packaging materials and all transport locks from the appliance.
NOTE
► You may notice a slight smell when using the appliance for the first time. This is
normal and is completely harmless.
Electrical connection
To ensure safe and trouble-free operation of the appliance after making the electrical
connection, please observe the following advice:
CAUTION
► Before connecting the appliance, compare the connection data (voltage and
frequency) on the rating plate with that of your mains power supply. These data
must agree so that no damage is sustained by the appliance.
► Ensure that the mains power cable is not damaged and is not running over hot
surfaces and/or sharp edges.
► Ensure that the mains power cable is not taut or knotted.
Inserting/changing the remote control battery
If the battery in the remote control
25
is dead, a new CR2032 battery needs to be
inserted.
♦ Open the battery compartment
30
on the underside of the remote control
25
(see description on the rear of the remote control
25
).
♦ Remove the old battery from the remote control
25
.
NOTE
► Please follow the disposal instructions (see section
Disposing of the batteries
).
♦ Insert a new CR2032 battery into the battery compartment
30
.
Ensure the +/- terminals are correctly aligned.
♦ Slide the battery compartment
30
back into the remote control
25
.
Fitting the feet
♦ Place the appliance upside down on a soft surface, e.g. a carpet.
♦ Fit the feet
6
to the bottom of the appliance using 2 screws
34
on each foot.