background image

- 4 -

Cleaning and Care

 

Danger

Do not open any part of the housing. There are no
operating elements inside. An open housing can create
the risk of a life-threatening electrical shock. 

Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered
components.

Before cleaning the appliance,...

• first, remove the plug from the power socket and

allow the appliance to cool down completely.

• Clean the exterior surfaces and the power cable

with a slighly damp cloth. Be sure to dry the
appliance well before taking it back into use.

• For stainless steel surfaces, you can use appropriate

cleaning agents from a specialized dealer. 

• Never use any cleansers, abbrasive substances

or solvents. These can damage the appliance.

In the event of scale deposits

• Before descaling, remove the pourer sieve 

8

(see chapter "Removing/replacing the pourer
sieve").

• Take any decalcifying agent used for kitchen

utensils (e.g. decalcifiers for coffee machines)
from a grocery shop. Proceed as detailed in the
instructions provided for the use of the decalcfying
agent.

Removing/replacing the pouring sieve

• Open the lid

1

.

• Press from the front against the upper lug sitting

in the middle of the pouring sieve 

8

and at the

same time hold it firmly by the flap.

• Remove the pourer sieve 

8

.

• Clean the pouring sieve 

8

with a lightly moistened

dishcloth and under running water.

• After cleaning it, place the pourer sieve 

8

from

inside against the opening. Ensure that the lower
and the lateral lugs grip the opening. Press the
pourer sieve 

8

until the upper lug engages in

the opening.

• Should the scale deposits in the pourer sieve 

8

be firmly settled, lay it in a water-vinegar solution,
with a ratio of 6:1, for a few hours. The scale
deposits will dissolve themselves. Rinse the pourer
sieve 

8

with lots of clear water.

Storage

Allow the appliance to cool off completely before
putting it into storage. 
• Wind the power cable around the cable winder 

5

under the base 

4

.

• Store the appliance in a dry place.

IB_57454_SWKS2400A1_LB6  09.09.2010  16:50 Uhr  Seite 4

Summary of Contents for SILVERCREST SWKS 2400 A16









Reviews: