Silvercrest SHBS 3.7 A1, Operating Instructions Manual

Page: 15 / 156

13 GB
6.4 Trimming a beard
Beard trimmer attachment 13
NOTE: please note that the cutting lengths will only be
achieved if the switch for cutting length fine tuning 6 is at po-
sition 1 and the hair and beard trimmer 5 is held at a right an-
gle to the skin surface.
• Comb the beard in the direction that it grows.
• Trim the beard downwards from ear to chin. First trim one
side, then the other.
• Comb attachment1
Figure C:
adjust the cutting length with the slider accord-
ing to the desired hair length and read off the cutting
length using the marking on the side of the comb attach-
ment
1
(3, 4, 5, 6 mm). Now, shorten your beard step-by-
step.
• Use the beard trimmer attachment 13 without a comb at-
tachment 1 , to cut the beard very short or to cut a mous-
tache and hairline.
• Using the switch for cutting length fine tuning 6 the cutting
length can be slightly varied with three levels ( 1 : 0.8 mm /
2 : 1.3 mm / 3 : 1.8 mm).
• To trim your moustache, first comb it straight downwards.
Then use either the beard trimmer attachment 13 or the
precision trimmer attachment
4
. Start at the centre above
the mouth and trim first one side, then the other.
BB.5$B%ERRN6HLWH'LHQVWDJ'H]HPEHU