13
GB
10. Cleaning and care
DANGER!
~
Pull the mains plug out of the wall socket
before you clean the device.
~
Allow the device to cool down before
cleaning.
CAUTION:
~
All parts becoming damp or wet, must
be dried completely prior to the next
use.
~
Do not use any astringent or abrasive
cleaning agents.
Switch off the device prior to cleaning and
remove the battery.
Cleaning of the suction device
and the battery
• Use a damp, soft cloth to clean the suc-
tion device
|
5
, the floorhead
|
21
and the
battery
|
32
.
Cleaning the nozzles (except for
the floorhead) and the exten-
sions
• The parts can be cleaned under running
water.
Cleaning of the metal filter and
the exhaust air filter
• The metal filter
|
11
and the exhaust air
filters
|
2
can be cleaned under running
water.
Cleaning of the motor protection
filter and the paper filter
• The motor protection filter
|
12
and the
paper filter
|
6
are tapped out.
Replacing the filters
• Check all filters regularly for damage or
deformations. Damaged or deformed
filters or filters that cannot be cleaned
anymore must be replaced to maintain
the full effectiveness of the vacuum
cleaner and to avoid damage to the de-
vice.
• Filter sets can be reordered (see “Order-
ing accessories” on page 15).
Cleaning the rotating brush in-
side the floorhead
1. Turn the floorhead
|
21
upside down.
2. Press the fastener with the double arrow
to the outside. This is a bit difficult so
that it will not disengage during vacuum
cleaning.
3. Remove the rotating brush
|
24
from the
floorhead
|
21
.
4. Tap out the brush
|
24
slightly. Has, for
instance, hair been caught, use your fin-
gers to pull them off.
5. Reinsert the brush
|
24
into the floor-
head
|
21
.
6. Press the small fastener back into the di-
rection of the brush.
11. Storage
If you do not want to use the device for ex-
tended periods, keep it in a dry location.
__CPE284657_Staubsauger_B7.book Seite 13 Dienstag, 13. Dezember 2016 2:36 14
