Silvercrest SFA 4.1 E1, Operating Instructions Manual

Page: 93 / 132

SilverCrest SFA 4.1 E1
English - 91
The LED of the car charger adapter lights up green. The standby button (8) lights up green while charging. A full
charge cycle takes approximately 3 hours. The standby button (8) will go out when charging is complete. Disconnect
the car charger adapter from the in-car socket and the hands-free kit.
CAUTION! Charge the battery only when the engine is running to save your vehicle’s battery.
The battery can also be charged on a PC or using an external mains adapter. A connecting cable with appropriate
micro-USB plug is required for this.
9.2 Switching the hands-free kit on/off
Press the standby button (8) for about three seconds until you hear a series of beeps and buttons 3, 4, 5 and 8 flash
briefly several times. The hands-free kit is now ready for use. If a connected device is in range, buttons 3, 4, 5 and 8
will flash blue briefly once about every ten seconds. If no connected device is in range, the device goes into
search/pairing mode.
To switch the hands-free kit off, hold down the standby button (8) for about two seconds. A beep sounds, button 3
flashes orange briefly several times and then goes out completely.
9.3 Establishing connection with compatible mobile phones
Pairing/Connecting
Only on first use and following a reset to factory settings, the hands-free kit will start directly in pairing mode after
holding down the standby button (8) for about three seconds. The mute button (3) will flash alternately orange and
blue.