Silvercrest SEMK 105 A1, Operating Instructions Manual

Page: 31 / 132

■ 28 │
GB
│
IE
SEMK 105 A1
Operation and use
Filling the appliance
CAUTION! PROPERTY DAMAGE!
►
Never fill hot water into the water tank ! The water temperature should
be between 8 and 25 °C.
NOTE
►
Before filling the appliance, make sure that the cap is firmly in the drain
opening on the underside of the appliance. Otherwise, the filled water
will flow straight out again.
♦
Open the lid and take out the ice basket .
♦
Use a container such as a measuring cup to fill the water tank .
Never exceed the MAX marking.
♦
Replace the ice basket in the appliance and close the lid .
Starting ice cube production
WARNING
►
Always use fresh drinking water to prepare ice cubes. Never reuse the
water from thawed ice cubes!
♦
Press the button to start ice production.
The control lamp lights up permanently green.
♦
After around 7 –15 minutes, depending on the water and ambient
temperature, you will hear ice cubes start to fall into the ice basket .
To remove ice cubes, open the lid and remove the required amount of
ice cubes using the ice scoop . Then close the lid again.
♦
If the "Ice full" lamp lights up red, the ice basket is full. Ice cube
production is stopped and the appliance stops cooling. As soon as you
have removed enough ice cubes, the appliance will resume production.
NOTE
►
Sometimes, the finished ice cubes pile up and obstruct the light sensor. Ice
cube production is then stopped, even though the ice basket is not yet
full. If this happens, use the ice scoop to redistribute the ice cubes in
the ice basket so that the light sensor is no longer obstructed. Ice cube
production will resume automatically.
♦
If the "Add water" lamp lights up red, the water fill level is too low. Ice
cube production is interrupted and the appliance stops cooling. If you want
to continue producing ice cubes, fill the water tank as described in the
section "Filling the appliance".