SECM 12 B2
GB
│
IE
│
15
■
assembly
Use the diagrams on the fold-out page as a guide
for assembly!
1) Remove all packaging materials and any
stickers from the appliance .
2) Clean the appliance as described in the
section "Cleaning and Care" .
3) Place the base
0
on a flat surface .
4) Insert the drive shaft
6
into the corresponding
recess on the ice scraper
7
until the ice
scraper
7
clicks into place .
5) Insert the other end of the drive shaft
6
into
the corresponding drive shaft socket
3
.
6) Put the lid
5
on the freezer bowl
9
. Ensure
that the symbol on the lid
5
points at the
symbol on the freezer bowl
9
. Turn the lid
5
clockwise until it clicks into place . The symbol
on the lid
5
points at the symbol on the
freezer bowl
9
.
7) Insert the plug into a mains power socket .
The appliance is now ready for use .
Preparation
♦
Place the freezer bowl
9
in the deep freeze
for about 24 hours at a temperature of no more
than -18°C .
Tips
►
Keep the freezer bowl
9
upright in the
freezer .
►
Ensure that the beakers
9
are completely
dry before you place them in the freezer .
►
Store the fruit, milk and cream in the refrigera-
tor before processing . This ensures that the
fruit is already cold and thus the ice cream
mixture will not require so long to cool down .
►
Place a plastic bag, for instance a freezer
bag, in the freezer bowl
9
before freezing .
♦
Puree the fruit with a hand blender and mix all
the ingredients as described in the recipe .
♦
Allow the mixture to cool down for approx .
4 hours .
making ice cream
caUTIoN! PRoPERTy DamaGE!
►
Start the appliance first and then add ingre-
dients . Otherwise, the ice mixture will freeze
onto the sides of the freezer bowl
9
and
block the ice scraper
7
. This will cause the
motor to overheat!
►
Do not stop the appliance during processing!
Otherwise, the ice mixture will freeze onto
the sides of the freezer bowl
9
and the ice
scraper
7
will be blocked when you switch
the appliance back on . This will cause the
motor to overheat!
1) Remove the freezer bowl
9
from the freezer
and place it in the base .
2) Assemble the appliance as described in the
chapter titled "Assembly” .
3) Switch the appliance on by moving the On/
Off switch
1
to the position I . The whisk
7
starts to turn .
4) Now, fill the prepared ice mixture into the
freezer bowl
9
through the filling opening
4
.
Ideally, use a bowl with a spout . Never add
more than 1000 ml . During processing, the
mixture increases in volume!
5) Allow the appliance to continue running until
you are satisfied with the consistency of the
mixture . The ice cream is ready after 40 min-
utes at the most .
6) Switch the appliance off at the On/Off switch
1
and pull the mains power plug out of the
socket .
7) Turn the lid
5
until you can take it off .
8) Pull the ice scraper
7
out of the ice cream .
If the ice cream sticks to it, scrape it off with a
plastic spoon or similar tool .
9) Lift the freezer bowl
9
out of the appliance
and remove the ice cream . Use only plastic or
wooden implements to do this .
caUTIoN! PRoPERTy DamaGE!
►
Do not use metal utensils to remove the ice
cream from the freezer bowl
9
. They can
scratch the freezer bowl
9
.
IB_290154_SECM12B2_LB8.indb 15
08.11.17 16:40
