24 GB
flow rate controller
3
to the desired
steam flow rate
and start ironing.
The steam will ...
… start to come out as soon as you hold
the steam iron horizontal, and
… stop as soon as:
- you hold the steam iron vertically,
- you place the steam iron into the
stand
7
,
- the temperature is too low,
- the water tank
15
is empty
or
- you set the steam flow rate control-
ler
3
to
.
7. Finish ironing, set the temperature con-
troller
17
to
MIN,
set the steam flow
rate controller
3
to
and pull out the
mains plug
9
.
8. Allow the steam iron to cool down, and
pour off any remaining water from the
water tank
15
through the filling open-
ing in the water tank (under the lid
2
).
7.6 Steam jet function
The steam jet function requires a high tem-
perature. Select a temperature setting be-
tween
and
MAX.
For this purpose, the
water tank
15
must be at least one quarter
full. The steam flow rate controller
3
is locat-
ed to the left on the symbol
.
• Press the steam jet button while the
steam iron glides over the item of laun-
dry
4
.
• Wait a few seconds before you press
the steam jet button
4
again.
NOTE:
For smoothing items of clothing that
are hanging up, you can use the steam jet
Button in a vertical position.
8. Cleaning
DANGER!
~
Pull the mains plug
9
out of the wall
socket before you clean the steam iron.
~
Allow the device to cool down before
cleaning.
CAUTION:
~
Do not use any astringent or abrasive
cleaning agents.
Cleaning the device
• For cleaning the device, use a soft,
moistened cloth.
• Dirt can be removed from the sole
plate
20
using commercially available
cleaning agents for chrome, silver or
stainless steel.
• Residues that have melted on can be re-
moved by heating the steam iron up to
the
MAX
setting and then ironing an
old cotton cloth.
Self-cleaning
CAUTION:
~
Do not put vinegar, limescale remover
or any other additives into the water
tank
15
. Additives can damage the de-
vice.
If you use tap water, you should run the self-
cleaning cycle after every use. Otherwise
use the self-cleaning cycle at least twice per
month.
1. Fill the water tank
15
.
2. Place the steam iron in the stand
7
.
3. Connect the mains plug
9
with the wall
socket.
4. Set the steam flow rate controller
3
to
and set the temperature control-
ler
17
to
MAX.
__317392_Dampfbuegeleisen_B8.book Seite 24 Donnerstag, 20. Juni 2019 1:08 13
