Silvercrest 377153 2110, Operating Instructions Manual

Page: 12 / 150

SDRB 1000 B1
GB
│
IE │
9 ■
♦ If your clothes are heavily creased, use the
steam function by pressing the steam burst but-
ton
8
. To produce steam, set the temperature
control
3
to ••• or higher .
♦ If the heat-up indicator lamp
5
lights up during
operation, do not press the steam blast button
8
again: wait a few seconds until the heat-up
indicator lamp
5
goes out .
♦ Only repeat pressing the steam burst button
8
until the heat-up indicator lamp
5
lights up or
water drips from the ironing sole
0
. Wait until
the heat-up indicator lamp
5
goes out before
initiating another burst of steam .
NOTE
► If you press the steam burst button
8
while
the heat-up indicator lamp
5
is illuminated,
the appliance will produce condensation
instead of steam, and water will drip from the
ironing sole
0
.
♦ If the water tank runs dry during operation
1
,
pull the mains plug
7
before refilling it .
♦ To set the appliance down briefly during opera-
tion, unfold the stand
9
to the front and lean
the appliance on it . To resume use of the appli-
ance, simply fold the stand
9
back to the rear .
After using the steam brush
♦ Set the temperature control
3
to “MIN” .
♦ Always disconnect the plug
7
from the mains
power socket after use .
♦ Empty the water tank
1
by opening the filler
opening
2
of the water tank
1
, turning the ap-
pliance upside down and swinging it gently .
Cleaning and care
WARNING – RISK OF INJURY!
► Always disconnect the mains plug
7
before
cleaning the appliance . There is a risk of
electric shock! Allow the appliance to cool
down .
Risk of burns!
CAUTION
► Do not use aggressive cleaning agents . These
may damage the surfaces .
♦ Clean the housing with a soft, dry cloth only .
♦ Clean the metal parts of the appliance with a
damp cloth and a mild, non-scouring detergent .
♦ To clean the ironing sole
0
, wipe it with a
damp cloth and a small amount of dish soap .
Descaling
The appliance must be descaled regularly to main-
tain its maximum performance . The frequency of
descaling depends on the quality of the water and
the frequency with which the appliance is used .
We recommend that you descale the appliance
either once a year or after 50 hours of total use .
We recommend descaling immediately, however,
if you notice that the appliance is generating less
steam .
NOTE
► You can do this with a regular descaling
agent containing citric acid .
Also observe the instructions for the descaling
agent .
1) Ensure that the appliance has completely
cooled down .
2) Add the descaling agent to the water tank
1
.
3) Insert the plug
7
into a properly installed and
grounded wall socket .
4) To produce steam, set the temperature control
3
to ••• or higher . The heat-up indicator lamp
5
lights up . As soon as the selected temperature
has been reached, the heat-up indicator lamp
5
goes out .