English
17
Note:
You can cut down the heating-up time
by using warm water.
Î
Screw the safety cap (A4) back onto the de-
vice.
Î
Place the unit securely on a firm surface.
Caution
The appliance must not be carried during clean-
ing.
Î
Insert the mains plug (A7) into a socket.
Both indicator lamps (A2/A3) must illumi-
nate.
Caution
Do not turn the appliance on without water in the
boiler. Otherwise, the appliance may overheat
(see Help with faults)
.
Î
The orange indicator lamp (A3) goes out af-
ter approximately 8 minutes.
The steam cleaner is ready to use.
Î
Push the steam switch lock (B3) to the back.
Note:
If you push the lock forward, the steam
switch cannot be actuated (child control).
Î
While operating the steam switch (B4), direct
the steam gun at a separate piece of cloth
until the steam is emitted evenly.
Note:
The heating of the steam cleaner is
turned on in regular intervals during the op-
eration of the appliance in order to maintain
the pressure in the boiler at a constant level.
When the heating is turned on, the orange
indicator lamp (heater) lights up.
Î
Use the steam switch (B4) to regulate the
discharged steam.
Î
The lock of the steam switch (B3) also allows
for steam volume regulation.
–
Switch in front position: no steam (child con-
trol)
–
Switch in middle position: reduced steam
amount
–
Switch in back position: maximum steam
amount
Water needs to be filled into the boiler, if the
steam volume decreases during work and no
more steam is emitted in the end.
Note:
The safety lock (A4) cannot be opened as
long as slight pressure remains in the boiler.
Î
Push the steam lever (B4) until steam dis-
charge stops. Now, the boiler of the appli-
ance is unpressurized.
Î
Disconnect the mains plug (A7) from the
socket.
Î
Remove the safety cap (A4) from the device.
Danger
A residual amount of steam may be emitted
when you open the safety lock. Be careful when
opening the safety lock, there is a risk of scald-
ing.
Î
Fill the boiler with a maximum of 1.2 liters of
fresh tap water.
Danger
If the boiler is hot, there is the risk of scalding as
the water may splash back during the filling proc-
ess! Do not fill any detergents or other additives
into the boiler!
Î
Screw the safety cap back onto the device.
Î
Insert the mains plug into a socket.
Î
The orange indicator lamp (A3) goes out af-
ter approximately 8 minutes.
The steam cleaner is ready to use.
Î
Disconnect the mains plug (A7) from the
socket.
Î
Press the cover of the appliance (A1) con-
nector to the bottom and disconnect the
steam plug (B6/H5) from the appliance con-
nector.
Î
Illustration
–
Put the extension pipes (E1) into the large
acessory compartments (A5).
–
Insert the manual nozzle (D1) and detail noz-
zle (C1) onto each extension pipe.
–
Put the round brush (C2) into the medium
acessory compartments.
–
Hook the floor nozzle (F1) into the parking
position (A6).
–
Wrap the steam hose (B5) around the exten-
sion pipes and insert the steam pistol (B1)
into the floor nozzle (F1).
Turning on the Appliance
Adjusting the Steam Quantity
Refilling Water
Turning Off the Appliance
Storing the Appliance
