Silvercrest 373895 2104, Short Manual

Page: 12 / 112

GB
│
IE
│
9 ■ SAS 7.4 LI D3
Installation of the wall bracket
DANGER – ELECTRIC SHOCK!
► Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket
3
.
Drilling into a current-carrying electric cable can be potentially fatal!
1) Insert the barrel plug
5
on the mains adapter
4
into the wall bracket
3
as
shown in the following diagram:
First, feed the cable through the cable routing and then push the barrel plug
5
into the opening in the wall bracket
3
so that it is firmly in place. Secure the
barrel plug
5
by turning it.
2) Select a suitable installation location for the wall bracket
3
:
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter
4
.
3) Drill two holes about 60 mm apart. Use the wall bracket
3
to mark the
holes, to ensure the correct spacing. The drill holes must be suitable for 6 mm
wall plugs.
4) Push the wall plugs into the holes and then screw the wall bracket
3
firmly
into place using the screws.
5) You can place the nozzles on the accessories holder on the side.
6) Connect the mains adapter
4
to a mains power socket.
Charging
NOTE
► Check to ensure that the on/off switch
6
has been pushed back (to the
position "0") before starting the charging process.
■ Place the handheld vacuum cleaner from above into the wall bracket
3
so
that the barrel plug
5
slips into the socket on the handheld vacuum cleaner.
The charge indicator lamp
7
lights up red and the charging process begins.