10 GB/IE/NI
Assembly
Accessory needed: Cross head screwdriver
Number of persons needed for assembly: 1 adult
Fig. Step
C
1 . Remove the knurled screw
[
14]
from the
pole on the motor unit
[
9]
.
2 . Place the pole on the base
[
13]
.
3 . Fasten with the knurled screw
[
14]
.
D
Pull off the protective sleeve from the motor
shaft
[
6]
. Discard the protective sleeve .
E
Remove the 4 lock screws
[
15]
from the motor
unit
[
9]
.
F
1 . Align the rear grille handle
[
5]
upwards
and to the rear . Attach the rear grille
[
4]
to the motor unit
[
9]
.
2 . Tighten with the 4 lock screws
[
15]
.
G
1 . Place the blade
[
2]
on the motor shaft
[
6]
.
Insert the pins on the motor shaft into the
groove
[
3]
on the rear of the blade .
2 . Tighten the lock cap
[
1]
on the motor shaft
[
6]
(direction of rotation: ) .
Fig. Step
H
1 . Remove the lock screw and the lock
nut
[
17]
from the front grille
[
18]
.
2 . Loosen the grille clips
[
16]
from the front
grille
[
18]
.
3 . Centre the hanging device
[
19]
of the front
grille
[
18]
on the rear grille
[
4]
.
NOTE:
The 4 grille clips
[
16]
must fit over
the frame of both grilles
[
4]
[
18]
.
I
Insert and fasten the lock screw and the lock
nut
[
17]
. Close the 4 grille clips
[
16]
over the
frame of both grilles
[
4]
[
18]
.
NOTE:
The lock screw and the lock
nut
[
17]
are very small . Do not lose or drop
these fasteners .
Tilt adjustment
Loosen the knob
[
12]
.
Adjust the tilt angle manually .
Tighten the knob
[
12]
again .
Do not perform the tilt adjustment when the
product is in operation .
Operation
Place the product on a flat, stable ground .
Connect the power plug
[
10]
to a suitable
socket-outlet .
Fan speed
Rotate the speed control knob
[
7]
to turn the
product on/off and to select the fan speed
setting:
Position
Function
0
Off
I
Low fan speed
II
Medium fan speed
III
Maximum fan speed
