GB
│
IE
│
25
■
SSTME 600 A1
Operation
WARNING!
►
The motor switches off automatically as soon as the blender
3
is removed
from the motor block
6
or the lid
2
is opened. In such cases it may be
easy to forget that the machine is still switched on. The motor will then start
unexpectedly as soon as the blender attachment
3
is fitted or the lid
2
is
closed again:
Therefore:
–
Do not insert the power plug into the wall socket until the blender
3
is
filled and mounted with its lid fitted and closed.
–
Before fitting the blender, always check to see that the appliance is
switched off or that the power plug has been removed.
–
Switch the appliance off first, pull the plug out and wait until the motor
has come to a standstill before removing the blender
3
or opening the
lid
2
.
Fitting and filling the blender
1) Rotate the blender
3
anticlockwise until the arrow
T
under the blender
handle is located above the
position. Remove the blender
3
from the
motor block
6
in a vertical, upward motion.
2) Remove the lid
2
by rotating it anticlockwise towards position
(see Fig 1)
until you can pull it upwards.
3) Fill the blender
3
. Never exceed the MAX marking.
4) Press the lid
2
firmly down onto the blender
3
. Close the lid
2
by turning
it clockwise to position until it audibly engages (see Fig. 2). Ensure that the
pouring spout on the blender
3
is closed. The motor cannot start until the
lid
2
is fitted flush.
Fig. 1
Fig. 2
5) Press the measuring cap
1
into the lid as far as the stop.
IB_331510_SSTME600A1_LB8.indb 25
29.06.2020 15:04:46
Summary of Contents for 331510 2001
Page 3: ......