Silvercrest 331472 1907, Assembly, Operating And Safety Instructions

Page: 20 / 74

20 GB/IE
Risk of damage of the product
Only use the s pecified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before in-
serting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Installation
Note: A cross-head screwdriver is required to
assemble the product.
Remove the product and the accessories from
the packaging.
Assemble the base parts
16
in the shape of a
cross.
Screw the pole
13
to the base parts
16
using
the mounting plate
15
. Use the four cross-head
screws
17
to do this.
Remove the height adjustment ring
12
by rotating
it anticlockwise.
Push the cap
14
over the pole
13
. Then place the
height adjustment ring
12
back on the pole
13
.
Pull the internal pole
11
out of the pole
13
.
Secure the internal pole
11
by turning the height
adjustment ring
12
clockwise to tighten it.
Remove the fastening screw
10
by turning it
anticlockwise.
Push the motor
9
onto the internal pole
11
and attach it using the fastening screw
10
.
Turn it clockwise to tighten.
Remove the rear grille locknut
5
. To do this,
turn it anticlockwise.
Place the rear grille
6
on the motor
9
as
shown in Fig. D. Please ensure that the handle
on the rear grille
6
is located at the top.
Attach the rear grille
6
using the rear grille
locknut
5
. Turn it clockwise to tighten.
Remove the protective cover from the axle
7
.
Push the blades
4
onto the axle
7
. Ensure that
the smooth side of the axle
7
is facing down.
Place the blade cover
3
onto the axle
7
and turn it anticlockwise to tighten it.
Hang the front grille
1
on the rear grille
6
using the hook
2
. Connect both grilles
1 6
using the provided screw
19
and nut.
Then close the fastening clamps.
Before first use
Place the product on a flat and stable surface
and ensure that there is a minimum of 10 cm of
clear space around the product. This product is
not suitable for connection or use in a cupboard
or outdoors.
Connect the mains cable to the socket.
Note:
Before connecting the product, ensure
that the main voltage specified on the product
matches the local line voltage (Voltage:
220–240 V ∼).
Inserting / changing the battery
Open the battery compartment on the back of
the remote control.
Insert the batteries or replace the old batteries
with new ones. Only use batteries of the speci-
fied type („Technical data“).
Note: When inserting the batteries, please
observe the correct polarity. This is indicated in
the battery compartment.
Close the battery compartment.