SilverCrest SWDR 500 B1
English - 71
9.16 Manual station search
Power the device on.
Press the "BAND" button (7) to select the desired frequency band.
The short wave band "SW" is divided into 9 different frequency sub-
bands "SW1" to "SW9" (see the "Technical specifications" chapter).
To select the different short wave bands, start pressing the "MODE"
button (15) twice. The upper part of display reads “SW << >>”.
Press the "TUNE-" (13) or "TUNE+" (11) button to select the desired
SW band. Press the "MODE" button (15) again to start searching
for any stations.
Keep the "TUNE-" (13) or "TUNE+" (11) button pressed for approx. one
second to launch the station search down or upwards. The search will stop
when the next station has been found and its frequency is shown on the
display (6).
9.17 Manually tuning
a station
Besides the automatic station search, you can also tune in a station manually.
This allows you to also tune-in any weaker stations. Proceed as follows:
Briefly press the "TUNE-" (13) or "TUNE+" (11) button to increase or reduce
the frequency stepwise. These steps depends on the selected frequency band
and tuning spacing. Please also read the following chapter for different tuning
spacings.
9.18 Fine tuning
If you don't succeed to find a specific station, you can adjust the tuning spacing
to a finer setting (see the following table).
The procedure is as follows:
In radio mode, press the "Mode" button (15) once.
