Silvercrest 298815, Assembly, Operating And Safety Instructions

Page: 17 / 92

13 GB/IE/NI
Remove the used batteries, if present.
Insert 3 batteries (1.5 V (direct current), type AA).
Note: Ensure correct polarity. This is indicated in the battery
compartment
8
.
Close the battery compartment cover
6
.
Transmitter:
Remove the name plate from the holder
12
by pressing the lock
11
and remove the rubber cover
16
(see fig. C1).
Remove the used batteries, if present (see fig. C2).
Insert a battery (3 V (direct current), type CR 2032). The side
marked “+” must face upwards.
Install the rubber cover
16
, close the holder
12
of the transmitter
back on to the back of the product.
Fasten the holder, screw
15
of the transmitter back on to the back
of the product & name plate.
The transmitter battery compartment with the holder must be in-
stalled by the screw
15
while in use. If the holder is damaged,
stop using the product.
Synchronising transmitter / receiver
The product works on 434 MHz which is a quite common frequency.
To ensure that the function gets no influenced be doorbells in the
neighborhood, the transmitter and the receiver hence have to be syn-
chronized in regard of the encryption. Every transmitter is working
with a different encryption of the signal.