Silvercrest 296789, Operating Instructions Manual

Page: 95 / 123

■ 92 │
GB
│
MT
SEM 1100 B3
19) Push in the “Steam” button
4
so that it clicks into place .
20) Hold a container under the milk frother
0
and slowly turn the steam control
button
7
to the position “ + “ as soon as the green heating-up control lamp
5
lights up .
21) After about 1 minute, close the steam control
7
(turn it in the direction of the
“ - “ as far as the stop), press the “Steam” button
4
again and switch off
the appliance .
NoTE
► If no button is pressed, the appliance turns off automatically after
30 minutes .
Troubleshooting
Malfunction Cause solution
The espresso no longer
flows out .
• The espresso powder is too
moist and/or compressed
too tightly .
• Re-prepare the espresso
without compressing the
powder as firmly; if neces-
sary, use new powder .
• No water in the water tank
9
.
• Fill the water tank
9
with water .
• The holes of the sieve holder
openings are blocked .
• Clean the sieve holder
u
.
The espresso drips over
the edges of the sieve
holder
u
, not from the
openings .
• The sieve holder
u
is not
correctly inserted .
• Insert the sieve holder
u
correctly .
• The sieve holder openings are
blocked .
• Clean the sieve holder
u
.
• There are espresso powder
residues on the edges of the
sieve holder
u
.
• Clean the espresso
powder residues from
the edges of the sieve
holder
u
.
The espresso is cold .
• The appliance was not
preheated .
• Preheat the appliance.
• The green heating-up control
lamp
5
has not yet glowed .
• Wait until the green
heating-up control
lamp
5
lights up .
• The cups were not pre-warmed. • Pre-warm the cups.
The pump is unusually
noisy .
• The water tank
9
is empty .
• Fill the water tank
9
with water .