SPPB 5000 A1
GB
│
IE
│
NI
│
11
■
Using the power bank as a light
The power bank has a lighting attachment .
♦
Place the lighting attachment on the power bank.
♦
Press the ON/OFF button for approx. 3 seconds to switch
lighting attachment on or off.
NOTE
►
The power consumption of the lighting attachment is
150 mA. When using the lighting attachment , the second
USB port may only be loaded with maximum 1.95 A.
Troubleshooting
The power bank does not charge
♦
Cable connection faulty. Check the connection.
A connected device will not charge
♦
The integrated battery is empty. Charge the battery.
♦
No connection to the device. Check the connection.
♦
Press the ON/OFF button to start the charging process.
♦
The charging current of the connected device is too low
(< 50 mA) or too high (> 2.1 A).
♦
The internal overcurrent protection has been triggered.
Disconnect the attached device and connect the micro-USB
charging port to a power source for a short while (see
section
Charging the power bank
).
Afterwards, the power bank can be used again.
IB_286204_SPPB5000A1_DE-95x140_LB6.indb 11
24.05.17 16:26
