Silvercrest 277706, Operating Instructions Manual

Page: 19 / 113

SDBS 2400 A1
■ 16
│
GB
│
IE
│
NI
NOTE
If the appliance is used regularly, it is advisable to always have a replacement
limescale filter available. This means that you can replace the limescale filter
immediately as soon as the "anti calc" indicator lamp
!
lights up.
You can order new limescale filters from our service department (see
section
Ordering replacement parts
).
1) Switch the appliance off using the On/Off button
0
and allow it to cool
down.
2) Remove the power plug from the mains power socket.
3) Remove the iron from the base station and put it to one side.
4) Open the shaft cover .
5) Pull the limescale filter upwards out of the limescale filter shaft.
6) Place the new limescale filter in the limescale filter shaft and press it down
until it is firmly seated.
7) Close the shaft cover .
8) Insert the plug into a mains power socket and switch on the appliance using
the On/Off switch
0
.
9) Press the "RESET" button
.
for about 3 seconds. The "anti calc" indicator
lamp
!
goes out.
You have now completed replacement of the limescale filter .
Cleaning the appliance
♦ Clean the iron surfaces and the base station using only a soft, slightly moist
cloth.
♦ Clean the sole of the iron with a soft moist cloth. Ensure that the sole of
the iron is not scratched.
♦ Pour the residual water in the water tank into a basin. To do this, put the
iron down to one side and open the water tank filler cap .
♦ The appliance must be completely dry before further use.