Silver Marine Calypso 300 WD, Owner'S Manual

Page: 6 / 16

5
PACKING LIST
Calypso 300 WD & Calypso 330 WD:
Boat Hull, Oars, Foot Pump, Pressure Gauge, Wooden Seat, Docking Rope, Safety Grab Line, 4
Screw 1 Drain Valve, Repair Kit, Carry Bag, Boat Cover and Bench Bag.
4 pieces Floorboards; 3 pieces Stringer (66cm); 2 pieces Stringer (90cm).
INSTALLATION TIPS
Tip 1: Although the boat is designed to be assembled by one person, an additional person can make it
substantially easier.
Tip 2: Make sure to tuck the wood floor edge in correctly to the aluminium stringers.
Tip 3: Make sure to press down and turn the pop-up spring valve 90 degrees before inflating. (The default
setting is for deflation.)
Tip 4: If using an electric pump, after tube inflation, use a foot pump to add a little more air to ensure
correct pressure.
Tip 5: In case the valve is loose, screw it tight with the black plastic wrench included in the accessories.
Tip 6: In case you find difficulty when installing the bench seat, put your knees on one of the inflated
tubes to add pressure to the bench.
HOW TO SET UP THE BOAT?
STEP ONE: STARTING UP
1. Unfold the hull
Clear a flat area (make sure it is clean and free of sharp objects). Remove the hull from box and take off
the plastic bag. Unroll the hull and lay it out flat.
2. Screw Valve Installation
1
2.2
UP
DOWN
(A) INFLATE (B) DEFLATE
2.1
PRESS AND TURN 90
3
4
1. Take off the top of the valve. (The valve by
default is at deflation position)
3. Insert the inflation adapter to the valve. Secure
the adapter by turning it clockwise. Connect the
pressure gauge and pump to the adapter. Start
inflating until the pressure reach 0.25 bar.
2. Press down the spring switch and turn it clockwise by 90 degrees.
Make sure the switch is popped up. Note: To deflate, press the inner
button at the center and turn counterclockwise 90 degrees.
4. Remove the pressure gauge and pump. Put the cap on the valve.