Page 2
www.matcotools.com
Model:
SE135
Product Type:
AIR BELT SANDER 3/4" x 20.5"
Sanding Belt Replacement Instructions:
1) Disconnect air supply from sander.
2) Push #1 idle pulley in the direction shown in the photo below
until tension bar automatically locks into place.
3) Loosen #29 thumb screw slightly and rotate #28 belt cover to
right until belt is completely exposed.
4) Remove old belt, install new belt, rotate #28 belt cover to left
and tighten #29 thumb screw.
5) Push #21 lock lever in to unlock #7 tension bar and the #1
idle pulley will automatically apply tension to the belt.
WARNING
Always keep hands away from pulleys and disconnect air supply before
servicing this tool to prevent serious injury.
Sanding Belt Alignment Instructions:
If the sanding belt is off center of the #1 idle pulley during
operation, an adjustment should be made for safety and to
prevent premature wear of the belt and other tool parts. If the
belt is running off center away from the #28 belt guard, turn
the #9 screw clockwise to move the belt toward the #28 belt
guard until centered with the #1 idle pulley, and counterclockwise
to move the belt away from the #28 belt guard.
1) LUBRICATION:
Before connection of the hose, apply 4 to 5 drops of a good
quality air tool oil at the air inlet. After 3 to 4 hours of
operation, oiling may be necessary again.
3) STORAGE:
Avoid storing the tool in a location subject to high humidity. If
the tool is left unused, the residual moisture inside the tool
can cause rust. Before storing and after operation, oil the tool
at the air inlet with a good quality air tool oil and run it for a
short period.
4) DISPOSAL:
Follow national legislation of waste disposal.
5) ORDERING SERVICE PART:
For further operational and handling information or for
replacement of parts and components, contact the sales
agent from where you purchased the tool, or the service
division of our company, phone number 800-221-9705.
*When ordering parts and components, give each part
number, name, and quantities.
2) TIGHTNESS OF PARTS:
Regularly check whether all connection parts are
fastened securely. Follow this procedure daily
before beginning work.
MAINTENANCE INSTRUCTIONS:
