japa
315+
User manual
Translation
13
315+ 2.0 - 2020
3.4 Cutting device
The JAPA 315 firewood processor is equipped with a hydraulic chainsaw, which only rotates during
sawing. The cutting device is also connected to a safety mechanism, which prevents sawing when the
working area guard is open (3.3). The length of the log to be cut can be adjusted between 20 and 50 cm.
When a new log is being fed in for sawing, the pusher moves forward and then returns to the inner position
during sawing.
In case of problems, see Chapter 6 of the manual. Troubleshooting
A. Adjust the log length limiter to the desired
measurement (20–50 cm).
B. Close splitting area guard.
C. Feed the log in by pushing the handle (at the
same time, the pusher moves towards the knife).
D. Begin sawing by pulling the handle (the pusher
returns to the inner position during sawing).
DO NOT PLACE YOUR HAND NEAR THE CUTTING SAW WHEN THE MACHINE IS RUNNING!
DO NOT LEAVE THE SAW HANDLE IN THE LOWER POSITION WHERE THE SAW SPINS
CONTINUOUSLY!
ENSURE THAT THE LOG BEING SAWN IS SUPPORTED BY THE REAR EDGE OF THE
TABLE!
